Early 90's 2 Stroke 60 HP 3 cylinder 2 Carb Mercury Outboard Motor. Came on a project pontoon boat I am building and going with a different engine. Previous owner said it ran fine for them. Compression is 140/145/149 in the cylinders. I fired it off on a little brake cleaner to verify it will run. Carbs may need cleaned and needs fresh fuel for sure. This also comes with the console to start, steer and forward/reverse controls. Great if you're building a pontoon boat or small houseboat. A couple items to be addressed is there is a plastic bracket that needs replaced where the forward/reverse cables attach to the engine (currently held on with zip tie). The lower end is filled with some type of grease instead of gear lube (just seems different to me, but I'm not an outboard mechanic so maybe it is normal). I have the console with the controls removed. Ready to put on your boat. The steering cable is about 13' long. The console sat about 8' forward of the motor. 4 bolts and 2 clamps and the motor is ready to be loaded in your truck, trailer, or bring your boat and we can set it right in place.